EPP-619 - Current relay

Current relay is used to control the value of the current in the circuit measured with switch contacts function in the case of the value of current above the set threshold values.

Activation of relay is signaling by shining of the green LED “U”. By potentiometer is set the activation value of current. If set value of current is below of set threshold, then the joint is open (position 11-10). If set value of current exceeds of set threshold, then the joint is close (position 11-12) with set the time delay “t”. Exceeds of set threshold is signaling by shining of red LED

Technical features

• Power supply voltage 230 V AC
• The executive element relay
• Maximum load current 16 A
• Contact configuration 1 × NO/NC
• Separation of the contact YES
• Time of return 0,5 s
• Power return hysteresis 10%
• Diameter of the through hole 4 mm
• Current of the measuring circuit limited by conductor cross-section (maximum Ø: 4 mm)
• Switching current - adjustable 0,6÷16 A
• Operating time - adjustable 0,5÷10 s
• Terminal pluggable terminal blocks 2,5 mm²
• Tightening torque 0,4 Nm
• Power consumption 0,4 W
• Working temperature -25 ÷ 50 °C
• Dimensions 1 module (18 mm)
• Assembly on rail 35 mm
• Ingress Protection Marking IP20