L-DALI-RM1
The LDALI-RM relay module allows control of standard loads via a DALI channel. The built-in relay contact can be used for currents up to 8 A respectively loads up to 2,000 VA. The module is designed for a maximum inrush current of 8 A.

LDALI-RM modules are connected directly to a DALI channel and are powered directly from the DALI channel.
Together with LOYTEC DALI controllers, the LDALI-RM1 acts as a programmable output module. Integrating the module into the DALI network follows the same simple steps as integrating a DALI lamp. The LDALI-RM1 device is a control device for non-dimmable loads according to the DALI IEC62386-208 specification (Device Type 7).

Dimensions (mm) 32.5 x 15.2 x 60 (L x W x H)
DALI bus power, typ. 2.6 mA at a 16 V DC DALI power supply
Operating conditions 0 ° C to 45 ° C, 10 - 90% RH, non-condensing, protection degree: IP20
interfaces
1 x DALI, protected against overvoltages (power supply)
1 x relay output, contact, single pole, potential-free, bistable *

Rated load and rated current AC 2,000 VA / 8 A

Rated load and rated current DC 150 W / 5 A
Relay ON / OFF switching voltage
250 V AC / 30 V DC
Max. inrush current peaks AC 80 A, zero-cross switching
Switching cycles 5 x 105
Max. allowed switching frequency 1 Hz